How to use

How to use


Connect to a good quality three pin 15 amps plug to the geyser cable with green wire connected to the earth terminal ( thicker pin in the plug ). If the geyser is to be fitted permanently at one location only then it is advisable to connect it with a D.P. switch to avoid burning of wires due to loose connections in three pin plug and socket.

Drill two vertical holes on the wall at a distance in the wall bracket holes
provided with the geyser and insert plastic plugs into them. Secure the
unbreakable plastic bracket to these holes by tightening the two screws
provided with it.

Hang out the geyser by inserting the plastic hook into the notch provided in
the bracket by tilting the geyser at an angle. Please note that the geyser does not lift upward or loose contact with the bracket when pushed vertically upward with light force. This is to ensure that the geyser does not come out of the bracket with slight jerks while in use. To remove the geyser from the bracket tilt it at an angle till the plastic hook comes out from the notch in the bracket.

Connect inlet pipe to the water source with the PVC union, run water till it
flows out from the inlet pipe. This ensures that the water level in the non conductive special polymer container is enough to keep the heating elements immersed in water for its safety and long life.

Close water tap. Your Hot-Pot geyser is now ready for use. Switch on the
power supply, red bulb will glow.

Allow stored water to heat up for approximately one minute, open water
tap slowly to get running hot water and adjust flow of water to suit your requirement.